STEP 1
Download the SwiftPaws app. Select the appropriate app store for your phone:
STEP 2
Test the equipment to make sure it's working - before setting up the course.
STEP 3
Set up the course.
The max course size is 100 feet (for example: a square approx. 25 feet per side). Your actual course size depends on multiple factors. Keep in mind that anything that adds drag to the system may require that the course be a bit smaller to accommodate this. See: How to determine your maximum course size
STEP 4
Adjust the line tension so that it is the very lightest tension possible. See this video that demonstrates a quick simple way to adjust for proper line tension.
STEP 5
Play! Keep your finger on the pawprint button in the app while you slide it up or down to control direction and speed. Lift your finger to stop.
PLAY SESSION
A play session is 90 seconds and shows as 1:30 in the app. It begins to count down as soon as you move the button. At the end of the play session the drive will stop. After your pup catches their breath and maybe gets some water, you can initiate a new play session.
NOTE: Unplug the drive when not actively playing, and store it out of reach/sight when play is over.
SLEEP MODE: If you leave the drive plugged in but sitting idle, it will go into sleep mode. Unplug it for at least 30 seconds and plug it back in. If the blue light on the bottom of the drive does not begin to blink, press and hold the pairing button (while it's plugged in) until it comes on. See: Chase paring button on device
See the Chase videos here: https://support.swiftpaws.com/kb/chase-videos